If you are a do-it-yourself aficionado, then you will likely know how to install an overhead garage door in Passaic County all by yourself. Installing a garage door is not difficult, provided you have the necessary tools and skill set. If this is your first time, it is recommended you do it alongside a professional or a friend with previous experience. This will prevent injuries.
The following step-by-step instructions will guide you in installing your overhead garage door:
Required Tools and Materials
You will require the following:
- Socket bit
- Open-ended wrench
- Safety glasses
- Drill bits
- Phillips driver bit
- Adjustable locking pliers
- 1.2” diameter rods
Step 1: Remove the existing door
Always use the instructions mentioned in your manufacturer’s guidelines to remove your current door. You will be required to unlatch the door off the pulley system, take apart the panels of the door and unscrew the tracks. Ensure you remove a panel at a time or they might fall on you.
Step 2: Measure, Attach the handles and hinges
Measure areas such as door-opening height, headroom, width and back room. For headroom, ensure you have up to 12” of space. For back room, take in door height plus an additional 18” of space. Now start by attaching step to either side of the opening. Ensure they are flush with the door jamb inside edge. Use the sawhorses to lay the bottom piece of your new door and attach weather stripping. Attach hinges and lift the handles to the piece.
Step 3: Put the bottom piece into position
Put the bottom piece into your door frame. Ensure it is leveled properly. Once in place, put nails partway in each jamb. Bend the nails a little to help secure them. Using manufacturer’s instructions, assemble the curved, vertical and horizontal pieces of the track and put aside.
Step 4: Install remaining panels
Install the 2nd panel atop the first one. Hammer nails into side jambs to keep it in place. Install hinges and then repeat this process for the number of panels remaining. Each piece needs to be anchored into the door jamb.
Step 5: Secure tracks & attach springs
Once the vertical tracks are secured, install the curved and horizontal pieces. While installing the horizontal pieces, use your level and previous measurements to ensure that the tracks are in straight and pointing away from the entry at 90 degrees. Once the tracks are secured, put in the springs according to the instructions mentioned in the manual provided by the manufacturer. Get a friend to help you lift the door halfway to make sure that the tracks are parallel and level. Then lift the door to the remaining distance and hook the springs onto the pulley system.
Learning how to install an overhead garage door in Passaic County is quite simple if you are a DIY enthusiast. If this is your first time, it is recommended you hire a professional.